
mimas Pro user manual v4.1
23
8. Battery and charger
8.1 Charging
Connect the power supply to the charger cradle. Connect the power supply to a wall
socket.
Place mi
mimi
mimas
masmas
mas Pro to the charger as shown on the picture. The device gives a short signal
tone when its placed correctly and the charging begins. During charging the indicator
LED blinks rapidly. When mi
mimi
mimas
masmas
mas Pro is fully charged the indicator light is turned off. If the
battery has a very low charging the signal tone is given after a pre-charge sequence. After
the pre-charging sequence the charging process is continued normally.
Typical charging time for the battery is approximately two hours and is limited to
maximum of three hours. The battery achieves its best charging capacity after about ten
full depletion and charging sequences.
8.2 Battery level indications
When the battery is low the indicator LED blinks red. mi
mimi
mimas
masmas
mas Pro sends an SMS when the
battery level is low. In this case please charge the battery when possible. When the battery
is depleted the device sends a message ”Disarmed” before turning itself off.
Comentarios a estos manuales