Benefon TWIG CONFIGURATOR Manual de usuario descargar pdf (Pagina 28)

CONFIGURATING LOCATOR

28

can be set to:

00.00.10

...

00.59.59

(hh.mm.ss).

Default value is

00.30.00

(thirty minutes).

Config 13: GPS update in Tracking mode

You can define time interval for GPS position

updates in the tracking mode. Valid values are

between:

00.00.10

...

00.59.59

(hh.mm.ss).

Default value is

00.10.00

(ten minutes).

Config 14: GPS update in Anchor mode

You can define time interval for GPS position

updates in the anchor mode between:

00.00.10

...

00.59.59

(hh.mm.ss). Default value

is

00.01.00

(one minute).

Config 15: Max. allowed movement in Anchor

mode

You can define a maximum distance that

Locator is allowed to move from the original

position in the anchor mode. Once the limit is

exceeded, a movement alarm is triggered.

Allowed distance can be set to:

0100

...

9999

meters. Default value is

0300

(300 meters).

Config 16: Battery alarm level

Locator can alert you when its battery level is

declined under certain level. You can define

the alarm level at

20

,

40

, or

60

percentage of

full battery charge. Default value for the

alarm is

20

percent. If the value is set to

00

, it

means that the alarm is deactivated.

Note, that battery levels can vary substan-

tially when using Timer modes with long OFF

periods. This may cause wrong or repeating

Low battery alarms.

CONFIGURATION SETTINGS 17-32

Config 17: !IND messages

You can define whether !IND messages can be

sent or not. A !IND message is sent when

anchor alarm is activated by pressing the

anchor button.

The default value for !IND messages is

NO

. If

you wish to enable sending !IND messages,

change the setting into

YES

.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Comentarios a estos manuales

Sin comentarios